Franklin Electric SUBMONITOR CONNECT Manual De Instalación Y Funcionamiento Del Propietario página 26

INSTALLATION AND SETUP
Programming: Advanced Setup > Security
Programming: Advanced Setup > Security
Mod
RW RC Display Name
bus
N/A Edit Passcode
Programming: Advanced Setup > Administration
Mod
RW RC Display Name
bus
500 RW N Hardware >
External CT Ratio
N/A RW N Display Com Trip
N/A RW N Backlight
N/A RW N Contrast
506 RW Y Return States
102 RW N Reset
Parameters
103 RW N
104 RW N
N/A RW N Language
26
Range
00000 to 99999;
default = 00000
Range
0 - NONE (default)
1 - 150:5
2 - 200:5
3 - 250:5
4 - 300:5
5 - 500:5
6 - 600:5
7 - 800:5
8 - 1000:5
Enabled (default) or
Disabled
0% to 100%; default,=,80%
0% to 100%; default,=,50%
Power Fail Mode:
Last or Off (default)
Reset KWH:
Reset Motor Time:
Reset Settings:
Choose from:
• English (default)
• Spanish
• Italian
• Portuguese
• German
• French
Description
Set a five-digit passcode to protect the SubMonitor
Connect from unauthorized changes to Basic Setup and
Advanced Setup menus. A setting of 00000 disables the
passcode feature, making all menus accessible.
Description
Turns Ratio for Installed External Current Transformers
(CT)
Choose whether to use the Display Communications Loss
alarm or not.
Set the level of backlight for the display.
Set the level of contrast for the display.
Choosing Last causes the SubMonitor Connect to return
to the last state it was operating in prior to the power
failure.
Press Enter to confirm resetting the KWH counter to zero.
Press Enter to confirm resetting the Motor Time counter
to zero.
Press Enter to confirm resetting all settings to Factory
Defaults.
Choose the preferred language interface for using the
SubMonitor Connect.