Demounting Tubeless And Supersingle Tyres - SICE S 58 LL Manual De Instrucciones

Move the tyre's rear bead beyond the pliers
and turn the wheel clockwise until mounting
is complete.
To make it easier to insert the inner tube
(Fig. 34) place the tyre on the surface.
Position the tool near the valve with the
reference mark flush with the rim and tighten
the pliers (Fig. 35) above the tool, then turn
the wheel clockwise.
NB: Preferably lubricate the beads and the
well area of the wheel with grease before
mounting and demounting tyres.
DEMOUNTING
TUBELESS AND
SUPERSINGLE TYRES
Break the front part of the tyre, keeping
the bead pushed in the well, lubricate
the shoulder of the rim (Fig. 36) and the
bead with grease.
Repeat the bead breaking operation in
the rear (Fig. 37).
N.B.: If the rim has a 15° sloping shoulder,
continue the bead breaking procedure
(Fig. 38) until the tyre has come com-
pletely out of the rim (tyres up to 13" in
width only).
WARNING: In compliance with the in-
dications of the tyre manufacturers,
this procedure is not recommended:
beads must be broken one at a time,
proceeding as described for agricultural
wheels.
To mount particular rigid super single
tyres and tubeless tyres on rims with
very tall, even shoulders, lubricate
thoroughly and proceed as described for
agricultural wheels.
- E
- Operator's manual
nGlISH
35
36
37
38
79