Inflating Tubeless Tyres (Gp Versions Only) - SICE FIT LINE 32 Manual De Instrucciones

If necessary:
- Continue inflating up to the maximum value of 3.5 bar
to position the tyre correctly on the rim. Avoid distrac-
tions during this operation, and continually check tyre
pressure on the air pressure gauge (1 Fig. 36) to prevent
excessive inflation.
- Inflating tubeless tyres requires a higher air flow-rate to
allow the beads to bypass the rim HUMPS - see types
of rim profiles for mounting without a camera in fig. 37.
- From the position of the centring ridges check that the beads are properly positioned
on the rim; otherwise, deflate the tyre, break the beads as described in the relevant
section, lubricate and turn the tyre on the rim. Repeat the mounting operation described
previously and check again.
- Replace the internal mechanism of the valve.
- Bring the pressure to the operating value by pressing the Inflation push-button (2 Fig. 50).
- Fit the cap to the valve.
9.7.c. INFLATING TUBELESS TYRES (GP VERSION ONLY)
Before carrying out the operations described below, always make sure that there is no
dirt, dust or other impurities on the jaws near the air outlet holes.
118
WARNING
FITLINE 32 - 32 2V - 32 GP - 32 GP 2V
User Manual
1
2
"HUMP" (H)
"double HUMP" (H2)
36
37