skilsaw SPT99T Instrucciones De Funcionamiento Y Seguridad página 19

INSTALLING ANTI-KICKBACK PAWLS
Always install the anti-kick-
WARNING
back pawls onto the riving
knife with guard when performing "through
cutting" operations. Replace dull or dam-
aged anti-kickback pawls.Dull or damaged
pawls may not stop a kickback increasing
the risk of serious personal injury.
Anti-kickback pawls should only be installed for
through cuts .
1 . Turn off the table saw and disconnect the power
cord .
2 . Raise the blade by turning the height adjusting
wheel clockwise .
3 . Install the riving knife with guard .
4 . Press in the pawl release button and insert the
slot in the pawl joint into the riving knife notch .
Press down on the joint (Fig . 9) .
NOTE: It may be easier to install the pawls from
the front of th saw .
5 . Gently tug on the pawl joint to ensure it is locked
into place . Ensure the pawls move freely and
are not engaged in the throat plate slot .
NOTE: The two attachments are independant
of each other, so the Anti-Kickback Device can
be attached before the Guard Assembly .
FIG. 9
1 Press button
3 Press down
2 Insert
Assembly
Verify that the guard barriers are functioning prop-
erly throughout the full range of motion: bevel and
blade height:
1 . With the Smart Guard System assembled, set
the blade to the maximum height .
2 . Raise both barriers (left and right) until they both
lock in their raised positions .
3 . Apply a downward force to release the barriers
from their locked position: both barriers should
be in contact with the table .
4 . Bevel the tool from 0° to 45° and then back to 0° .
The barriers should remain in contact with the
table top and should not contact the blade
throughout the complete motion .
5 . Lower the blade to the lowest cutting height:
both barriers should be in contact with the table .
6 . Repeat Step 4 with blade in lowest cutting
height position .
7 . If barriers do not remain in contact with tabletop
or if they contact the blade at any time, do not
use the saw . See the assembly section to make
sure that the blade guard is assembled properly
or have the saw serviced by an authorized ser-
vice center .
Anti-Kickback Device
-19-
BARRIER VERIFICATION