Unpacking And Checking Contents - skilsaw SPT99T Instrucciones De Funcionamiento Y Seguridad

To avoid injury from unex-
WARNING
pected starting or electrical
shock during unpacking and setting up, do
not plug the power cord into a source of
power. This cord must remain unplugged when-
ever you are assembling or making adjustments
to the table saw .
Separate all parts from the packing materials
and check each one with the illus tration and
the list of Loose Parts to make certain that all
items are accounted for before discarding any
packing material (Fig . 3) .
If any parts are missing, do
WARNING
not attempt to assemble the
table saw, plug in the power cord or turn the
switch on until the missing parts are obtained
and are installed correctly.
TABLE OF LOOSE PARTS
ITEM DESCRIPTION
1 Table Saw
2 Table Insert
3 Barrier Guard Assembly
4 Anti-Kickback Device
5 Miter Gauge
6 Push Stick
7 Manual

Unpacking And Checking Contents

REMOVE CABLE TIE AND
(Used for shipping purpose only)
With the table surface on the ground, locate the
cable tie that anchors the motor/blade assembly
to the base . Using scissors or wire cutters, cut
and remove the cable tie (Fig . 4) .
Release the blade tilt lock handle, tilt the blade to
45 degrees, then remove styrofoam block located
between the motor housing and the table .
QTY .
1
1
1
1
1
1
1
FIG. 3
-15-
STYROFOAM BLOCK
FIG. 4
Remove
Styrofoam
Block
Remove
Cable Tie