Attaching The Guard Assembly - skilsaw SPT99T Instrucciones De Funcionamiento Y Seguridad

Sierra de mesa de tornillo sin fin de 8-1/4 pulgadas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ATTACHING THE GUARD ASSEMBLY

1 . With one hand, hold the front of the barrier
guard assembly by the "fork ." With the other
hand, hold the guard release lever up (Fig . 7) .
2 . Lower the rear of guard assembly and slip the
cross bar into the rear notch on top of the
riving knife (Fig . 7) .
FIG. 7
FIG. 8
Guard
Assembly
Assembly
3 . Lower the front of the guard assembly until
the "fork" is parallel with the table (Fig . 8) .
4 . Press down on the guard release lever until you
feel and hear it snap into the locking position .
Check that the guard assembly is securely
connected (Fig . 8) .
Guard Release
Lever
Riving Knife
Guard Release
Lever
-18-
Rear Notch
Cross Bar

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido