Instructions For Use; Push-Button Panel; Lift Lifting; Lift Lowering - Corghi ERCO 4004 Manual De Uso

Tabla de contenido

Idiomas disponibles

5.0 INSTRUCTIONS FOR USE

WARNING: Carefully read the indications set forth in sect. "General Safety and Accident-Prevention Rules".

WARNING: Before carrying out any operation using the control panel, make sure that nobody is close to the lift.

The operations to be carried out using the push-button panel are:

• Check that EMERGENCY SWITCH/DISCONNECTOR/OFF (17, Fig.1) is set to 1 (ON), turn it if necessary. The VOLTAGE WARNING LED

(18, Fig. 1) will light.

• Press the UP push-button (20, Fig. 1) until the desired height is reached.

• Press the DOWN push-button (21, Fig.1) until the mechanical safety locks are fully engaged to complete the braking phase.

• Press the UP push-button (20, Fig. 1) and the SAFETY LOCK RELEASE push-button (22, Fig. 1) simultaneously to allow the lifting of the runways by

20÷25 mm before the beginning of the lowering phase as well as the release of the safety locks.

• Press the DOWN push-button (21, Fig. 1) while simultaneously keeping the SAFETY LOCK RELEASE push-button pressed until the desired height is

reached or until the runways stop (about 15 cm from the floor due to FCS limit switch operation).

For a complete lowering of the runways:

DANGER: Before using the lift, make sure that no unauthorised persons or animals are present within the hazardous area

(1, Fig. 2).

This check shall always be carried out before completing lift lowering movement, as this last phase has to be considered as particularly dan-

gerous for any people standing close to the hazardous areas delimited by the yellow stripe (Fig. 2).

• Press the DOWN push-button (22, Fig. 1) until the minimum height is reached.

• Press the UP push-button (20, Fig. 1) until the desired height is reached.

• Press the DOWN push-button (21, Fig.1); runways will slowly move downward until the mechanical safety lock is fully engaged.

WARNING: This operation shall always be carried out after each lifting before accessing the work area.

WARNING: Before accessing the work area under the lift, the emergency switch/disconnector (17, Fig. 1) shall compulsorily be

turned to 0 (OFF).

WARNING: Do not access the lift runways when the VOLTAGE WARNING LED (18, Fig. 1) is on.

WARNING: Before leaving lift unattended, besides turning the Emergency Switch/Disconnector (17, Fig. 1) to 0 (OFF), the operator

MUST also mechanically lock its rotating movement by inserting a padlock (NOT supplied with the lift) in the special hole.

Tabla de Contenido

Tabla de contenido