John Bean B 800 Manual Del Operador página 104

8
A
8
8
104
5-60b
5-61
5-62
5-63
Operation
Figure 5-60b OPTIMISATION "10", outside
— Rotate the wheel into marking position following the
arrows.
— In this position make a double mark on the tyre
outer side exactly perpendicular to and above the
chuck.
— Confi rm by pressing key 8.
The OPTIMISATION "11" screen appears (Fig. 5-62).
Figure 5-61 OPTIMISATION "10", inside
If the wheel cannotbe turned over on the rim (e.g.:
Asymmetrical and Directional),
— press key (A, Fig. 5-61), then
— continue as shown on screen OPTIMISATION
"10" (Fig. 5-60b).
If the wheel can be turned over on the rim;
— Rotate the wheel into marking position following the
arrows.
— In this position make a double mark on the inside
of the tyre, exactly perpendicular to and above the
chuck.
— Turn the tyre over on the rim (tyre changer).
— Confi rm by pressing key 8.
The OPTIMISATION "11" screen appears (Fig. 5-62).
Figure 5-62 OPTIMISATION "11"
— Push the tyre on the rim until the double mark
coincides with the valve (use tyre changer).
— Confi rm by pressing key 8.
The OPTIMISATION "12" screen appears (Fig. 5-63).