John Bean B 800 Manual Del Operador página 82

82
5-36
5-37
4-13
Operation
5.15.3 Alu 2P and Alu 3P weight application
modes:
5.15.3.1 Using the Laser Pointer
With the Laser Pointer mode active in Alu 2P and Alu
3P modes, the correction planes for stick-on weights
are accurately indicated by the laser pointer directly
on the rim (Fig. 5-36).
Note: When the indication is given by the laser, the
weight must be fi tted at the bottom of the rim at 5
o'clock, precisely where indicated by the pointer.
Weight application to the right of the Laser Dot (Fig.
5-37).
When a run is completed, the BALANCING
screen (Fig. 4-13) shows the correction values
and the position of the weights to be applied.
To carry out corrections:
• Select a stick-on weight of the indicated size.
• Move the wheel until the correction position is reached
and the two green arrows light up.
• Before applying weights, press brake pedal to lock
the wheel in this position.
• Apply the counterweight and manually press stick-on
weight against rim (Fig. 5-36).
• Repeat this procedure to balance the other side of
the wheel.