John Bean B 800 Manual Del Operador página 110

8
8
8
110
5-69b
5-70
5-71
5-72
5-73
Operation
Figure 5-69b MINIMISATION "3"
— Rotate the wheel into marking position following the
arrows.
— In this position mark the tyre, on the outer side of
the wheel, precisely above the chuck.
— Confi rm by pressing key 8.
The MINIMISATION "4" screen appears (Fig. 5-70).
Figure 5-70 MINIMISATION "4"
— On the tyre changer, turn the tyre with respect to
the rim until the valve is aligned with the mark made
on the tyre.
— Confi rm by pressing key 8.
The MINIMISATION "5" screen appears (Fig. 5-71).
Figure 5-71 MINIMISATION "5"
— Clamp the wheel.
— Rotate the wheel until the valve is exactly
perpendicular to and above the chuck.
— Confi rm the valve position by pressing key 8.
The MINIMISATION "6" screen appears (Fig. 5-72).
Figure 5-72 MINIMISATION "6"
START is signalled on the screen
— Perform the wheel measuring run.
A measuring run is performed.
The MINIMISATION "7" screen, outside, is displayed
(Fig. 5-73) or the MINIMISATION "7" screen, inside,
appears (Fig. 5-75).
Indication H 0
Optimum condition has been achieved and cannot be
further improved.
— Continue as shown on screen BALANCING (Fig.
5-65).