John Bean B 800 Manual Del Operador página 144

144
Setting Parameters
Saving Changed Parameters
Changes to operating modes can be saved permanently
using the "Saving operating modes in the permanent
memory" function so they are retained every time the
machine is started up.
Operating modes that are changed but not saved are
reset to the pre-change value after the machine has
been switched off.
Saving modes of operation in permanent
memory
NO* = No storage
Active = Fixes the data in the permanent memory
Store in the permanent memory – a three–tone signal
is given to acknowledge acceptance.
If the mode stored in the permanent memory is to be
changed, enter the desired state (e. g. on or off) for
the mode in question and transfer it into the permanent
memory.
7.4.1 List of modes of operation
The possible changes of modes are described in the
following.
Setting modes of operation as recommended
See § 5. Switching on the machine.
NO* = No action
Active = Factory–adjusted modes of operations
are set.
The selected mode of operation can be transferred to
the permanent memory.
Language selection
Selecting the menu language. A number of languages
are available, such as: English, German, Italian,
French, Spanish, Portuguese, Russian...
Volume of the audible signals
Scale of volume 0 to 100 (low - high).
Factory–adjusted to 50.*
The selected mode of operation can be transferred to
the permanent memory.
Factory adjusted mode
* =
........