John Bean B 800 Manual Del Operador página 60

60
5-16
5-17
Operation "BALANCING MODE"
5.7.1 Advanced Spoke Detection
This mode, to be enabled in case of need and only in
F
"BALANCING" ( 5.9) and "BALANCE WITH RUN
F
OUT" modes ( 5.8), allows exact identifi cation of rim
spokes position and size.
It allows a more precise placement of weights behind
the spokes. If the laser scanners cannot recognise the
spokes or the operator decides he/she is dealing with
a rim with a particularly complex shape, enable the
Advanced Spoke Detection function which recognises
any type of spokes, even those with unusual shapes,
for example: paired, oblique, with holes or of different
sizes to one another (Fig. 5-16).
Before performing the measuring run:
•
From the SETTINGS screen select "Spoke Detection"
then "ADVANCED".
•
Perform the normal procedures for the run.
Note: This function increases the time for the total
measuring cycle by 5 seconds.
If the Spokes Count function is active, the screen
shown in the fi gure is displayed during the measuring
run (Fig. 5-17)
........