Water Output Connection - Espa MP-10 Manual De Instrucciones

ATTENTION
Before pumping water, install the filter at the end of
the hose. In this way foreign bodies are filtered out of
the water as these could cause obstruction or damage to the rotor.
Filter
ATTENTION
The hose connector and bracket should be checked to
prevent air leaks and the reduction of the suction force.
The motor drive pump's yield and capacity for auto-suction are re-
duced if the hose is loose.

3.5 Water output connection

Connect the water by means of a commercial hose, in addition to
the corresponding bracket and connector. Large diameter hoses are
more efficient while low diameter hoses increase the flow resistan-
ce and reduce the pump's output power.
ATTENTION
Ensure the bracket is well fixed to avoid the output
hose becoming displaced under conditions of high wa-
ter pressure.
Hose
Bracket
3.6 Oil level control
AAA requirements for the SF and SG main-
tenance levels for purity and viscosity (the
letters SF or SG will appear stamped on the
deposit sticker).
Hose
Use a type of oil that contains the adequate viscosity in accordance
with the average temperature (for example SAE 15W50).
cycle. Change oil when it is contaminated or after a determined
number of hours in accordance with the procedure indicated in the
maintenance section.
24
Bracket
ATTENTION
Do not use dirty vegetable oil.
ATTENTION
Use CLTC motor oil or an equiva-
lent which fulfils or exceeds the
ATTENTION
Check the oil level with the motor off and located on
a flat surface.
ATTENTION
If the oil were of low quality or deteriorated it would
cause motor problems and would shorten its useful life
EN
Hose