Test The Bark Control Collar; Accessories - SportDOG NoBark 18 Manual De Funcionamiento

TEST THE BARK CONTROL COLLAR

You can verify the Bark Control Collar is working properly by setting it to the Test Mode.
Important: To avoid feeling the static stimulation yourself, do not touch the two Contact Points
simultaneously.
1. To enter the Test Mode, advance the Bark Control Collar to High Mode
(see "Operate the Bark Control Collar").
2. In High Mode, press and hold the Mode Button for 2-3 seconds. The Indicator Light will turn
solid orange to indicate the unit is in Test Mode. Release the Mode Button.
3. Hold the unit by the collar strap with the Indicator Light facing towards you. The unit
should be within 15 cm - 25 cm of your mouth.
4. In order to trigger the unit, say "Test" loudly into the Sound-Activated Sensor.
5. The Indicator Light will flash orange three times to show that it is functioning properly.
6. If the Indicator Light does not flash, ensure that the battery is properly installed
and/or replace the battery. If the Indicator Light still does not flash, contact the
Customer Care Centre.
7. Return the Bark Control Collar to the Low Mode before replacing the unit on your dog by
pressing and holding the Mode Button for 2-3 seconds. The Indicator Light will flash green
every 5 seconds to indicate the unit is in Low Mode. NOTE: If the Bark Control Collar in
turned off while in Test Mode, it will automatically be in Low Mode when turned back on.
NOTE: The Test Mode is not intended for normal operation. If the Bark Control Collar is left in
Test Mode while on your dog, it can cause false correction and may reduce battery life.

ACCESSORIES

To purchase additional accessories for your SportDOG
Customer Care Centre or visit our website at www.sportdog.com to locate a retailer near you.
NoBark
®
SPORTDOG.COM
18 Bark Control, contact the
™
11