Sears Kenmore Elite 79046832101 Instrucciones De Instalación página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Anti-Tip Brackets Installation Instructions
To reduce the risk of tipping of the range,
the range must be secured to the floor by properly installed
anti-tip bracket and screws packed with the range. Those
parts are located in the oven. Failure to install the anti-tip
bracket will allow the range to tip over if excessive weight
is placed on an open door or if a child climbs upon it.
Serious injury might result from spilled hot liquids or from
the range itself.
Follow the instructions below to install the anti-tip
brackets.
If range is ever moved to a different location, the anti-tip
brackets must also be moved and installed with the
range.
Tools Required:
Adjustable Wrench
Ratchet
Drill & 1/8" bit
5/16" Nutdriver
Level
The anti-tip bracket attaches to the floor at the back of
the range to hold range rear center leg. When fastening
bracket to the floor, be sure that screws do not
penetrate electrical wiring or plumbing. The screws
provided will work in either wood or concrete.
O F
G E
E D
R
C K
E O
B A
L
A L
N G
ANTI-TIP
R A
W
BRACKET
A R
R E
C L
20-21/32"
L
A L
W
A R
R E
Rear Center Leg
Figure 13
(Models with an Electric Oven and a Gas Cooktop)
Kitchen
Cabinet
Door
Toe
Cabinet
Plate
10-11/32"
Draw a line
on the floor
SLIDE
BACK
1. Draw a line on the floor (in front of the cutout)
aligned with the front of the cabinet (not with the
toe plate).
2. Unfold paper template and place it flat on the floor
with the front and side edges positioned exactly on
the cabinet line you just drew before. (Use the
diagram below to locate brackets if template is not
available. (figure 13))
3. Mark on the floor the location of the 4 mounting
holes shown on the template. For easier installation,
3/16" diameter pilot holes 1/2" deep can be drilled
into the floor.
4. Remove template and place bracket on floor. Line
up holes in bracket with marks on floor and attach
with 4 screws provided. Bracket must be secured to
solid floor (figure 14). If attaching to concrete floor,
first drill 3/16" dia. pilot holes using a masonry drill
bit.
5. Be sure the 4 leveling legs are at the highest position
they can be.
6. Slide range into place making sure rear center leg is
trapped by the anti-tip bracket (figure 13). Lower the
range by adjusting the 4 leveling legs until the
underside of the cooktop is sitting level on the
countertop. Refer to "Leveling the Range" on page 6.
7. After installation, verify that the anti-tip bracket is
engaged by opening warmer drawer and looking
through openings in rear panel. If a storage drawer is
provided rather than a warmer drawer, open and
remove drawer and check to make sure the anti-tip
bracket is engaged.
Anti-Tip Bracket
Range
Floor
Floor Mount
Screws
10
Anti-tip Leg
Wall
Figure 14

Publicidad

Tabla de contenido
loading

Tabla de contenido