Leveling The Range; Check Operation - Sears Kenmore Elite 79046832101 Instrucciones De Instalación

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Installation With Side Panel(s)
1. Install base cabinets 30
Make sure they are plumb and level.
2. Install cabinet doors 31" (78.7 cm) min. apart so as
not to interfere with range door opening.
3. A backguard kit can be ordered through a Sears
Service Center.
4. An end panel kit can be ordered through a Sears
Service Center.
5. Follow steps 6 to 9 in "Installation Without Side
Panels" on previous page.
Installation With Backguard
5
The cutout depth of 21
/
increased to 24" (61 cm) when installing a backguard.

Leveling the Range

Level the range after installation in the cutout
opening.
1. Open the range drawer and remove the two metallic
caps covering the 2 leveling screws. These leveling
screws control the high of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop surface is sitting level on
the countertop (Figure 9).
a. To adjust the front leveling legs, use a wrench and
turn clockwise to lower or counterclockwise to
raise.
b. To adjust the rear leveling screws, use a ratchet or
a nutdriver and turn counterclockwise to lower or
counterclockwise to raise.
3. Check if the range is level by installing an oven rack
in the center of the oven and placing a level on the
rack (Figure 10)
4. Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
(Models with an Electric Oven and a Gas Cooktop)
1
/ " (76.5 cm) min. apart.
8
" (55 cm) needs to be
8
Figure 9
5. If the range is not level, contact a carpenter to
correct sagging or sloping floor.
6. Replace the metallic caps in position.

Check Operation

Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Do not touch the elements or burners. They may be hot
enough to cause burns.
Remove all packaging from the oven before testing.
1. Install Burner Bases and Burner Caps
This range is equipped with sealed burners as shown
(see Figure 11).
a. Unpack burner bases and burner caps.
b. Place burner bases over each gas opening.
c. Make sure the burner is properly aligned and
leveled. Place burner caps over appropriate
burner bases.
NOTE: There are no burner adjustments necessary on
this range.
Burner Cap
Burner
Base
Electrode
8
Figure 10
Gas
Opening
Figure 11