Rollixo RTS
usE aND oPEratioN
Normal operation
operation with a 2 or 4-button remote control
Press the programmed button to operate the door.
STOP
STOP
STOP
obstacle detection operation
During closing, the detection of an obstacle causes the door to stop and re-open partially.
The receiver warning light
flashes rapidly to indicate that the door has encountered an obstacle.
To return to normal operating mode, a command must be sent.
integrated lighting operation
The lighting comes on each time the motor is switched on. It goes out automatically 2 minutes after the
door has stopped moving.
Specific operation
Depending on the additional accessories installed and the operating options programmed by your installer,
the system may have the following specific functions:
operation with a 3-button remote control
STOP
Operation with orange flashing light
The orange light flashes each time the motorisation is switched on, with or without a 2-second warning
depending on the configured parameter setting. It stops flashing when the door stops.
operation with cells
An obstacle placed between the cells will prevent the door from closing.
If an obstacle is detected while the door is closing, it stops, then re-opens fully.
The receiver warning light
flashes rapidly until the obstacle is removed.
3
Copyright © 2012 Somfy SAS. All rights reserved