Adding Remote Controls - SOMFY ROLLIXO RTS Manual De Uso

Rollixo RTS
operation with the alarm
The alarm is triggered for 2 minutes if the door is raised manually. No movement of the door is possible
when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the receiver to stop it. The alarm
can only be stopped with a memorised remote control.
operation in automatic closure mode
Automatic closure of the door occurs out after a time delay programmed during installation.
A new command during this time delay cancels automatic closing and the door remains open.
The following command results in the closure of the door.

adding remote controls

This operation must be carried out close to the receiver.
This operation involves adding a remote control to your installation by copying a remote control already
used on your installation.
Remote control "a" = "source" remote control already memorised
Remote control "B" = "target" remote control to be added
2 or 4-button remote control
A
[1]. Press the outer left and right buttons on the previously memorised remote control simultaneously until
the green indicator light flashes.
[2]. Press the remote control button A which controls your roller garage door for two seconds.
[3]. Press the button on new remote control B which will control your roller garage door.
3-button remote control
4
A
2s
A
2s
B
B
< 1s
Copyright © 2012 Somfy SAS. All rights reserved