Memorising Remote Controls; Self-Learning - SOMFY Elixo 500 24 V Manual De Instalación

Elixo 500 24 V
Memorising the remote controls
To memorise a remote control:
[1] Press the PROG button on the control unit for 2
seconds. The red indicator light will come on.
[2] Press a channel on the remote control to which the
motorisation will be linked within 2 minutes. The
red indicator light fl ashes, the remote control has
been memorised.
If this procedure is carried out using a channel which
has already been memorised, this channel will be
cleared.
To add other remote controls: repeat the above
procedure.
To add a Telis type remote control:
[1] Press the PROG button on the control unit for 2
seconds. The red indicator light will come on.
[2] Press the PROG button on the back of the Telis.
This must be done within 2 minutes. The red
indicator light fl ashes, the remote control has been
memorised
To exit programming mode without memorising a
remote control: briefl y press the PROG button on the
control unit.

Self-learning

The gate's travel self-learning is essential when commissioning the motorisation.
During self-learning, the obstacle detection function is not active. Remove any objects or obstacles and do not
allow any persons near or inside the operating range of the motorisation.
To carry out an emergency stop during self-learning, use a memorised remote control.
Before beginning self-learning
Ensure the rail is clean.
Manually move the gate to the closed position.
Re-engage the motorisation:
[1] Turn the release handle to the left.
[2] Move the gate manually until the drive mechanism re-locks.
[3] Turn the key a quarter of a turn to the right.
SuC (closing end limit activated) should be displayed on the moto-
risation screen.
If SuO (opening end limit activated) is displayed, check the
motorisation wiring (see pg. 7).
Start self-learning
Self-learning comprises 2 cycles (1 cycle = 1 opening + 1 closing):
• The 1st cycle is carried out without slowing down and enables the
motor to memorise the gate's entire travel.
• The 2nd cycle includes slowing down in order to establish the
minimum torque value needed for movement of the gate.
[1] Press the OK button on the control unit twice to access the menus.
[2] Use the + and - buttons on the control unit to access the AutoSet
menu.
[3] Press the OK button to confi rm. Self-learning has started. The gate
must complete 2 full cycles.
8
2 s
[1]
2 s
[1]
[1]
[2]
OK
OK
- +
+ -
.......2 min........
[2]
.......2 min........
[2]
OK
OK
OK
Copyright © 2008 Somfy SAS. All rights reserved.