Conditions Of The Working Environment; Initial Commissioning; Switching On Torque Wrench - Garant 655010 Manual De Instrucciones

GARANT Electronic torque/rotational angle wrench HCT

6. Conditions of the working environment

Temperature
Relative atmospheric humidity
en
Height above mean sea level (MSL)
Pollution degree

7. Initial commissioning

A
CAUTION
Exploding rechargeable batteries
Risk of injury to hands and body.
» Use only the rechargeable battery supplied.
» In the event of damage, deformation or heat build-up, stop using the rechargeable battery.
» Only charge rechargeable batteries with the corresponding charger.
1. Turn rotary catch anti-clockwise with slot-head screwdriver and remove it.
2. Remove contact fuse.
3. Insert rotary catch and turn clockwise with slot-head screwdriver.

8. Switching on torque wrench

B
i
Torque wrench is tared automatically after each time it is switched on.
1. Place the torque wrench on a flat surface and keep it still.
2. Press and hold OK for around three seconds in order to switch on the torque wrench.
» "Tare - Do not move" is displayed.
CAUTION! Incorrect taring. Do not apply any loads to or move the torque wrench dur-
ing the taring process.
3. Taring process completed if the torque wrench switches to measurement mode.
» Last measurement mode is displayed.
34
-10 °C to +40 °C
90 %, non-condensing
0 m to 2000 m
3
Instruction manual