Data Transfer; Operation; Setting Pitch - Garant 655010 Manual De Instrucciones

10.4. DATA TRANSFER

i
Settings cannot be configured unless "HID" is activated.
20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Data transfer" and confirm with OK or the down function button.
3. Configure the following settings:
Send button
History on wrench

11. Operation

11.1. SETTING PITCH

20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
i
When using a plug-in head that is different to the reversible ratchet supplied, set the pitch
ü Reversible ratchet assembled flush with the arbor.
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Settings" and confirm with OK or the down function button.
3. Select "Measurement" and confirm with OK or the down function button.
4. In the case of "Effective length", enter determined pitch:
Effective length
20/02/2020 16:32
Connection
Data transfer
Workflow
Screw cases
Settings
Activate/deactivate Send button. If deactivated,
data will not be transferred via HID.
If Send button is activated: activate or deactivate
the ability to save the process to the torque
wrench. If deactivated, the process is transferred
via HID and not saved to the torque wrench.
20/02/2020 16:32
Connection
Data transfer
Workflow
Screw cases
Settings
www.hoffmann-group.com
DATA TRANSFER
Send button
History on wrench
SETTINGS
Display
Measurement
System
en
OFF
ON
MEASUREMENT
Unit Nm
Threshold 75%
3 s
Evaluation time
100.0 mm
Effective length
Alarm OFF
41