Menu Navigation; Measurement Modes; Torque - Garant 655010 Manual De Instrucciones

9. Menu navigation

9.1. MEASUREMENT MODES

9.1.1. Torque

20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Mode" and confirm with OK or the down function button.
3. Select "Torque" and confirm with OK or the down function button.
4. Select "Displaying" mode and confirm with OK or the down function button to measure the
torque without configuring further settings.
Select "Triggering" mode in order to configure further settings.
5. In the mode "Triggering", configure the following device settings and confirm with OK or
Lower function button:
UNITS
TARGET VALUE
MIN TOLERANCE
MAX TOLERANCE
DIRECTION OF ROTATION
ANGULAR MONITORING
6. For subsequent angle of rotation measurement, configure the following additional settings
and confirm with OK or Lower function button:
SNUG TORQUE
MIN ANGLE
MAX ANGLE
7. Then save the screw case.
20/02/2020 16:32
Measurement method
History
Connection
Data transfer
Workflow
Define desired unit for torque.
Define value of the target torque.
Define the lower tolerance limit for torque.
Define the upper tolerance limit for torque.
Define direction of tightening.
Activate or deactivate subsequent angle of rotation measure-
ment.
Define value of the snug torque.
Define the lower tolerance limit for target angle.
Define the upper tolerance limit for target angle.
www.hoffmann-group.com
MODE
Torque
MODE
Displaying
MODE
Triggering
35
en