Angle Of Rotation; History - Garant 655010 Manual De Instrucciones

GARANT Electronic torque/rotational angle wrench HCT

9.1.2. Angle of rotation

20/02/2020 16:32
Peak: ---
en
0
Nm
Calibrated
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Mode" and confirm with OK or the down function button.
3. Select "Angle" and confirm with OK or the down function button.
4. Make the following settings and confirm with OK or the down function button:
UNITS
SNUG TORQUE
TARGET ANGLE
MIN TOLERANCE
MAX TOLERANCE
DIRECTION OF ROTATION
TORQUE MONITORING
5. For subsequent torque measurement, configure the following additional settings and confirm
with OK or Lower function button:
MIN TARGET VALUE
MAX TARGET VALUE
6. Then save the screw case.

9.2. HISTORY

20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
i
A maximum of 1000 entries can be saved. After this, the oldest entries are overwritten.
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "History" and confirm with OK or the down function button.
3. Select entry.
 In order to display details, press OK.
 In order to delete all entries, press and hold the down function button for three seconds and
confirm with OK or the down function button.
36
20/02/2020 16:32
Measurement method
History
Connection
Data transfer
Workflow
Define desired unit for torque.
Define value of the snug torque.
Define value of the target angle.
Define the lower tolerance limit for angle of rotation.
Define the upper tolerance limit for angle of rotation.
Define direction of tightening.
Activate or deactivate subsequent torque measurement.
Define the lower tolerance limit for torque.
Define the upper tolerance limit for torque.
20/02/2020 16:32
Measurement method
History
Connection
Data transfer
Workflow
Instruction manual
MODE
Angle
HISTORY
15/07/20 11:18 60 Nm
19
29/06/20 19:12 44 Nm
19
29/03/20 16:27 73°
19
25/02/20 15:30 200 Nm
19
12/01/20 12:54 63°
19
04/01/20 10:13 11 Nm
19