Measurement; System - Garant 655010 Manual De Instrucciones

GARANT Electronic torque/rotational angle wrench HCT

12.2. MEASUREMENT

SETTINGS
en
Display
Measurement

System

1. Select "Measurement" and confirm with OK or the down function button.
2. Configure the following settings:
Unit
Threshold
Evaluation time
Effective length
Alarm
Vibration
12.3. SYSTEM
SETTINGS
Display
Measurement
System
1. Select "System" and confirm with OK or the down function button.
2. Configure the following settings:
Language
Factory setting
Master PWD
Screw case PWD
Workflow PWD
Overload info
44
Set measurement unit for torque measurement in the "Triggering" mode.
This unit will function as the standard value when creating a screw case.
Value (in percent) above the lower target value that, when reached, trig-
gers the signal ring to light up to alert the user.
Time after tightening procedure until the value of the applied torque is
evaluated and can be saved.
Set pitch.
Activate or deactivate acoustic signal.
Activate or deactivate vibration signal.
Set the system language and confirm with OK or Lower function button.
Reset to factory settings. All data and settings will be deleted.
Activate or deactivate master password. Password is requested when open-
ing the menu.
Activate and select/deactivate password for screw cases. When creating the
screw case, the password must also be activated.
Activate and select/deactivate password for workflows. When creating the
workflow, the password must also be activated.
Display whenever the maximum torque of the torque wrench is exceeded.
Instruction manual
MEASUREMENT
Unit
Threshold
Evaluation time
100.0 mm
Effective length
Alarm
SYSTEM
Language German
Factory setting
Master PWD OFF
Screw case PWD
OFF
Workflow PWD
OFF
Nm
75%
3 s
OFF
OK