Deleting Screw Case; Workflow; Creating A Workflow - Garant 655010 Manual De Instrucciones

GARANT Electronic torque/rotational angle wrench HCT

9.3.4. Deleting screw case

20/02/2020 16:32
Peak: ---
en
0
Nm
Calibrated
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Screw cases" and confirm with OK or the down function button.
3. Select screw case to be deleted.
4. Press the down function button.
5. Confirm deletion with OK or the down function button.

9.4. WORKFLOW

9.4.1. Creating a workflow

20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
FILTER MEASUREMENT METHOD
SCH1
SCH2
Target Target
Monitoring Monitoring
SCH3 SCH4
Target Target
Monitoring Monitoring
SCH5 SCH6
Target Target
Monitoring Monitoring
i
A maximum of 10 workflows can be saved.
ü Screw cases are created.
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Workflow" and confirm with OK or the down function button.
3. Select "New workflow" and confirm with OK.
4. Assign a name with a maximum of four characters using the up, down, left and right buttons.
5. Confirm with OK or the down function button.
6. Select with the left and right buttons whether the workflow is to be password-protected and
confirm with OK or the down function button.
i
In the case of active Workflow PWD: password must be entered in the case of an incorrectly
executed tightening procedure.
» Workflow created.
7. Select position for screw case to be created and confirm with OK.
8. Select "Torque" or "Angle" to filter saved screw cases and confirm with OK or the down func-
tion button.
9. Select "Screw cases" and add to workflow by pressing OK. Details about the screw case can be
displayed with the down function button.
10. Add further Screw cases.
11. After completion, press the up function button to save the Workflow.
38
20/02/2020 16:32
Data transfer
Workflow
Screw cases
Settings
Info
20/02/2020 16:32
Data transfer
Workflow
Screw cases
Settings
Info
FILTER MEASUREMENT METHOD
Torque
Angle
Instruction manual
SCREW CASES
New screw case
SCH1
SCH2
SCH3
SCH4
SCH5
WORKFLOW
New workflow
ARB1
ARB2
ARB3
ARB4
ARB5
WORKFLOW
Free position
Free position
Free position
Free position
Free position
Free position
20/02/2020 16:32
Delete screw case "xxxx"?
WORKFLOW NAME
A 0 0 0
Password
No