Editing Workflow; Calling Up Workflow; Deleting Workflow - Garant 655010 Manual De Instrucciones

9.4.2. Editing workflow

20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Workflow" and confirm with OK or the down function button.
3. Select the Workflow to be edited and confirm with OK.
4. Select "Edit" and confirm with OK or the down function button.
5. Edit name or confirm with OK or the down function button.
If the name stays the same, the current workflow is edited. If the name is changed, the workflow
i
is copied with the same values and then edited.
6. Select with the left and right buttons whether the workflow is to be password-protected and
confirm with OK or the down function button.
7. Select screw case and delete with the down function button.
8. Confirm deletion with OK or the down function button.
9. Add Screw cases according to "Creating a workflow [} Page 38]".

9.4.3. Calling up workflow

20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Workflow" and confirm with OK or the down function button.
3. Select the desired Workflow and confirm with OK.
4. Select "Activate" and confirm with OK or the down function button.
5. Carry out tightening procedure according to the procedure plan.
CAUTION! Tighten the screws specified by the workflow in the correct order.
6. Confirm screw case with send button, so that workflow can jump to next screw case. After the
last tightening procedure, it jumps back to the first screw case.
7. If the workflow is executed incorrectly, loosen all screws, check the workpiece for damage and,
if necessary, repeat the tightening procedure with new screws.

9.4.4. Deleting workflow

20/02/2020 16:32
Peak: ---
0
Nm
Calibrated
1. Press the down function button or OK, enter the password if necessary and confirm with OK.
2. Select "Workflow" and confirm with OK or the down function button.
3. Select workflow to be deleted.
4. Press the down function button.
5. To delete all workflows, press and hold the down function button for three seconds.
6. Confirm deletion with OK or the down function button.
20/02/2020 16:32
Data transfer
Workflow
Screw cases
Settings
Info
20/02/2020 16:32
Data transfer
Workflow
Screw cases
Settings
Info
20/02/2020 16:32
Data transfer
Workflow
Screw cases
Settings
Info
www.hoffmann-group.com
WORKFLOW
New workflow
ARB1
ARB2
ARB3
ARB4
ARB5
WORKFLOW
New workflow
ARB1
ARB2
ARB3
ARB4
ARB5
WORKFLOW
New workflow
ARB1
ARB2
ARB3
ARB4
ARB5
WORKFLOW
Activate
en
Edit
Details
WORKFLOW
Activate
Edit
Details
20/02/2020 16:32
Delete workflow
ARB2?
39