Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LOCATION
Do not locate the range where it may be subject to strong
drafts. Any openings in the floor or wall behind the range
should be sealed. Make sure the openings around the
base of the range that supply fresh air for combustion and
ventilation are not blocked by carpeting or woodwork.
The range, like many other household units, is heavy and
can be installed on soft floor coverings such as cushioned
vinyl or carpeting. Use care when moving the range on this
type of flooring.
Use a belt when moving the range to prevent damaging
the floor. Or slide the range onto cardboard or plywood to
avoid damaging the floor covering.
This appliance must not be installed with a ventilation
system that blows air downward toward the range.
This type of ventilation system may cause ignition and
combustion problems with the gas cooking appliance
resulting in personal injury or unintended operation.
When the floor covering ends at the front of the range,
the area that the range will be installed on should be built
up with plywood to the same level or higher than the floor
covering. This will allow the range to be moved for cleaning
and servicing, as well as proper air flow to the range.
Also, make sure the floor covering can resist 180°F (82°C).
See the "IMPORTANT SAFETY INSTRUCTIONS" (included in
this manual).
Make sure the wall coverings around the range can resist
the heat generated (up to 200°F/93°C) by the range. See
the "IMPORTANT SAFETY INSTRUCTIONS" (included in this
manual).
PREPARING FOR INSTALLATION
GAS PIPE AND ELECTRICAL
OUTLET LOCATIONS
30"
"
9
1
/
16
"
11
/
3
32
2"
3"
"
14
5
/
"
2
/
16
3
8
7
Recommended area for
"
8
19
/
120V outlet on rear wall
32
and area for through-the-
wall connection of pipe
stub and shut-off valve.
Recommended area
for through-the-floor
connection of pipe stub
and shut-off valve.
Publicidad
Tabla de contenido
