BM2 BIEMMEDUE SUPER 150 Manual De Uso Y Mantenimiento página 25

OBSERVED FAULTS, POSSIBLE CAUSES AND REMEDIES
OBSERVED FAULT
• The water cleaner won't start (pressing the
• black key of the magneto-thermal switch (1))
• During operation the machine stops and the
• magneto-thermal switch (1) switches off
• The water jet is regular but its pressure
• values are very low
• H.P. pump oil shows water traces
• The pump works with irregular pulsations,
• pressure variations and noise
CAUSES
• Electrical supply interrupted/insufficient
• Burnt fuse (T.S. only)
• Electrical supply interrupted/insufficient
• Thermal relay intervention for excessive
• current absorption
• Clogged lance nozzle
• Wrong nozzle
• Bypass valve not calibrated or dirty
• Pump body side sealing ring worn out
• High moisture percentace in the air
• Worn out seals
• Air suction in the water entrance pipe
• Detergent tap open and empty detergent tank
• Blocked bypass valve
• Pump seals worn out
• Inlet/delivery valves obstructed,
• dirty or worn out
• The machine is started without discharging
• the air completely from the circuit
• Worn out bearings
25
REMEDIES
• Check power supply characteristics
• Check electrical connections
• Replace de fuse
• Check power supply characteristics
• Check electrical connections
• Check that the water nozzle corresponds to
• the declared stock one
• Clean the water nozzle
• Adjust the bypass valve
• Clean the nozzle
• Replace the nozzle
• Clean and calibrate the valve
• Check and/or replace the sealing ring
• Replace oil twice in comparison with
• prescribed frequency
• Replace seals
• Check that the water entrance pipe and
• the water filter tap are tightly closed
• Fill the detergent tank and close the tap
• Remove the valve and clean it
• Replace the seals
• Check closure surfaces of the valves and
• clean them
• Disconnect the washing lance and let the H.P.
• pump work for a few seconds
• Replace the bearings
GB