Getting Ready To Sew Connecting The Power Supply - Janome MC 5200 Manual De Instrucciones

w
e
e
t
w
i
q
t
r
q
r
u
y
10
GETTING READY TO SEW
Connecting the Power Supply
CAUTION
Always turn the power switch off and unplug the sewing machine
from the electrical outlet when the machine is not in use.
To use start/stop button
Turn off the power switch.
Insert the machine plug into the machine.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
q Power switch
w Machine plug
e Machine socket for power supply
r Power supply plug
t Wall outlet
To use foot control
Turn off the power switch.
Pull out the foot control cable gently.
Insert the foot control plug into the machine.
Insert the machine plug into the machine.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
q Power switch
w Foot control plug cord
e Machine socket for foot control
r Machine plug
t Machine socket for power supply
y Power supply plug
u Wall outlet
CAUTION
Do not pull the foot control cable beyond the red mark to avoid
damage to the foot control.
i Red mark
NOTE:
The start/stop button cannot be used when the foot control is
connected to the machine.
CAUTION
When turning off the machine after straight stitch sewing, be sure
to open the needle plate hole to prevent the needle from hitting
the needle plate.
Press button to open the needle plate before turning the
machine off.
NOTE:
Do not turn the machine off while an hourglass
indicated on the LCD screen.
is