Bobbin Winding - Janome MC 5200 Manual De Instrucciones

z
q
x
e
c
v
b
r

Bobbin Winding

z Draw the thread from the spool.
x Insert the thread through the hole in the bobbin,
w
c Push the bobbin winder spindle to the right.
v With the free end of the thread held in your hand,
b Depress the foot control again. When the bobbin is
36
NOTE:
Set the speed control slider at its fastest position for
bobbin winding.
Guide the thread around the bobbin winding tension
disk.
Be sure to insert the thread between the tension disks.
q Bobbin winding tension disk
threading from the inside to the outside.
Put the bobbin on the bobbin winder spindle.
w Bobbin
e Bobbin winder spindle
The LCD screen shows bobbing winding sign.
depress the foot control. Stop the machine when
the bobbin has wound a few layers, and cut the
thread close to the hole on the bobbin.
fully wound, it will stop automatically.
Return the bobbin to its original position by moving the
spindle to the left, and cut the thread as shown.
Cut the thread with the bobbin thread cutter.
r Bobbin thread cutter