Replacing The Lamp; The Back Lamp; Troubleshooting; Service Data - Progress PHN1310S Manual De Instrucciones

Replacing the lamp

Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING! Danger of
electrocution! Disconnect the
fuse before you replace the
lamp.
The lamp and the lamp glass
cover can be hot.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The cooking zones do not
operate.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation set-
tle on the food and in the
cavity of the oven.

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
We recommend that you write the data here:
Model (MOD.)
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.

The back lamp

1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Possible cause
Refer to the operating instructions for the built-in cooking sur-
face.
The oven is deactivated.
The fuse is released.
The lamp is defective.
You left the dish in the oven
for too long.
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
.........................................
Progress 17
Remedy
Activate the oven.
Make sure that the fuse is the
cause of the malfunction. If
the fuse releases again and
again, contact a qualified
electrician.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.