Selecting The User Id; Using The User Id - Omron M10-IT Manual De Instrucciones

HEM-7080IT-E.book 22 ページ ２０１１年１１月１４日 月曜日 午後１時５３分
3. Using the Unit

Selecting the User ID

Select your user ID. Always use the same user ID when taking a
measurement. The unit stores the measurement values in the memory
by the user ID selected. These measurement values are used to
calculate the morning averages and evening averages.
Slide the user ID selection switch up or down to select user A or B.

Using the User ID

When you select a user ID the unit can be set to take one
measurement using the single mode or three consecutive
measurements using the auto mode when you press the O/I START
button.
Note: The default value is set to the single mode to take one
measurement.
The auto mode takes three consecutive measurements. The unit will
inflate the cuff and take three measurements separated by a short
interval of time between each measurement.
22