Selecting.the.user.id; Using.the.user.id - Omron Plus 10 Serie Manual De Instrucciones

TAkING A MEASUREMENT
seLeCtIng tHe UseR ID
Select.your.USER.ID ..Always.use.the.same.USER.ID.when.taking.
a.measurement ..The.monitor.stores.the.measurement.values.in.the.
memory.by.the.USER.ID.selected ..These.measurement.values.are.used.
to.calculate.the.Morning.Averages.and.Evening.Averages .
Slide.the.USER.ID.Selection.Switch.right.or.left.to.select.USER.A.or.B .
UsIng tHe UseR ID
After.you.select.a.USER.ID,.the.monitor.can.be.set.to.take.one.
measurement.using.the.Single.Mode.or.three.consecutive.measurements.
using.the.TruRead .Mode .
TM
NOTE:.. T he.default.value.is.set.to.the.Single.Mode.to.take.one.
measurement ..Refer.to."Setting.TruRead " .
TM
32