Selecting The User Id; Using The User Id - Omron HEM-790IT Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TAKING A MEASUREMENT
3. Inflation stops and the measurement is started. When the
measurement is completed, your blood pressure and pulse rate appear
on the display.

SELECTING THE USER ID

Select your USER ID. Always use the same USER ID when taking a
measurement. The monitor stores the measurement values in the
memory by the USER ID selected. These measurement values are used
to calculate the Morning Averages and Evening Averages.
Slide the USER ID Selection Switch up or down to select USER A or B.

USING THE USER ID

When you select a USER ID the monitor can be set to take one
measurement using the Single Mode or three consecutive measurements
using the TruRead
NOTE: The default value is set to the Single Mode to take one
measurement.
The TruRead
TM
The monitor will inflate, take a measurement, and deflate three times
separated by a short interval of time between each measurement.
TM
Mode when you press the START/STOP button.
Mode takes three consecutive measurements.
28

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido