Installation; Unpack The Machine; Attach The Edge Guide; Attach The Guard - GreenWorks STE302 Manual Del Operador

Cortabordes
Ocultar thumbs Ver también para STE302:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8

INSTALLATION

8.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
If the parts have damage, do not use the machine.
If you do not have all the parts, do not operate the
machine.
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
8.2

ATTACH THE EDGE GUIDE

Figure 2
NOTE
The edge guide can limit the cutting range of the
machine and decrease the risk of the damage caused
by the rotating cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
8.3

ATTACH THE GUARD

Figure 3.
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
Phillips head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4. Tighten the screws.
8.4

ASSEMBLE THE SHAFT

Figure 4.
1. Loosen the knob on the coupler.
2. Push in the release button on the lower shaft.
English
3. Align the release button with the positioning hole
and move the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
8.5

ATTACH THE AUXILIARY HANDLE

Figure 5.
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle and lower clamp on the
shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
8.6

INSTALL THE BATTERY PACK

Figure 6.
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.7

REMOVE THE BATTERY PACK

Figure 6.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

Figure 7.
1. Push the lock-out button and pull the trigger.
7
WARNING

IMPORTANT

WARNING
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido