Installation; Unpack The Machine; Attach The Guard; Assemble The Shaft - GreenWorks STE456 Manual Del Operador

8

INSTALLATION

8.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
8.2

ATTACH THE GUARD

Figure 2.
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
Phillips head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4. Tighten the screws.
8.3

ASSEMBLE THE SHAFT

Figure 3.
1. Loosen the knob on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole
and move the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
8.4

ATTACH THE AUXILIARY HANDLE

Figure 4.
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle and lower clamp on the
shaft.
English
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
8.5

INSTALL THE BATTERY PACK

Figure 5.
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.6

REMOVE THE BATTERY PACK

Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

Figure 6.
1. Push the lock-out button and pull the trigger.
2. Push the speed switch to the desired operating
speed. Push the speed switch to position 1 for low
speed or position 2 for high speed.
9.2

STOP THE MACHINE

Figure 6.
1. Release the trigger to stop the machine.
9.3

OPERATION TIPS

Figure 7.
Keep clearance between the body and the machine.
5
WARNING
IMPORTANT
WARNING
WARNING
EN