Cleaning And Maintenance - Royal Catering RCKC-6000 Manual De Uso

Procedures:
• Turn the loading arm into anticlockwise direction to remove cover.
• Pay close attention to the two blades when filling the container with food. Big
parts of food should be cut into smaller portions before before filling the con-
tainer. Warning: the food in container is not allowed to be more than 1/2 of the
total volume.
• Pay attention to the position of the user when working. In order to avoid dan-
gerous situations that may cause injuries, the position of the user must be stable
and vertical to the working table. It is forbidden to push or move the device
while working.
• Put the cover into initial position, and then rotate the loading arm until it will be
locked.
• Press the start-up button.
• It is forbidden to work with low speed for a long period of time.
• While device is working, if needed, extra food can be added via the hole on the
cover.
• Press the red stop button when the work is finished. Speed adjusting knob must
be turned to "0" position.
VIII. CLEANING AND MAINTENANCE
Daily cleaning
• Before cleaning always turn the speed adjusting knob to "0" position and cut off
the power.
• The device should be cleaned at least one time every day. If necessary, it can be
cleaned more often.
• The parts of the device that are in direct or indirect contact with food must be
cleaned.
• It is forbidden to use water or water jet to directly clean the device. Brushes or
other tools which may damage the surface cannot be used.
Steps of cleaning:
• Clean the cover, rotating blades axis and container:
• Rotate the loading arm, remove the cover, and the blade fixing axis and container
can be lifted easily. Then use water and neutralized detergent safe for food to
clean the above-mentioned parts.
Attention: gloves should be worn for protection while operating.
• Clean the machine body with a neutralized detergent and a wet cloth. Use dry
cloth to dry the machine after cleaning.
12
Belt
• There is no necessity to adjust the belt. The belt should be changed every nine
months, depending on the work intensity. At this time, you should contact the
after-sales department of your dealer.
Power cable
• Power cable should be checked regularly. If it is damaged, please contact the
after-sales department of your dealer.
Rev. 19.09.2017 Rev. 19.09.2017 13