medi circaid juxtalite Instrucciones De Uso página 4

English
level. Ensure that the bands are
placed in an alternating order.
Step 6: Once all bands are
secured, inspect the garment for
any gaps or creases. Adjust the
bands as necessary.
Step 7: Fold the top end of the
compressive undersock over the
lower leg compression garment
Doffing instructions
Detach all bands of the legging
starting with the top band. Fold
each band onto itself to keep the
hook and loop tabs lint-free.
Remove the compression
garment and then remove the
compressive undersock.
Using the Built-In-Pressure
card:
Step 1: Locate the Built-In-
Pressure card in your packaging.
Step 2: Identify your prescribed
pressure scale using the
color-coded system.
Step 3: Starting with the bottom
band, line up the vertical line on
the card with one of the BPS lines
on the bottom band.
Step 4: Note where the second
BPS line lines up with the card´s
compression ranges (6a).
Step 5: If the BPS line on the
garment either falls short (6b) or
goes beyond the correct
compression range (6c), readjust
the band as necessary so that the
second BPS line on the garment
is aligned with the prescribed
compression range (6a).
Completely loosen the band
before reapplying it if too much
tension has been applied.
Step 6: Repeat the steps 3 - 5 for
each band going up the leg. Be
sure to adjust all bands to the
same compression level. Bands
may need adjusting throughout
the day to maintain the
prescribed compression range.