Handling And Operating Method; Assembly Of Nozzle; Assembly Of Waist Stabilizer - Maruyama MS0735W Manual Del Usuario

3. Handling and operating method

Assembly of nozzle

Wide nozzle
After confirming the packing is in place, securely tighten nozzle pipe to grip, and wide nozzle to nozzle
pipe. Tighten the screw securly after confirming the packing to make ensure there is no water leakage.
Over-tightening will cause extrusion or break the packing. Correct tightening pressure is important.
Discharge
End of spraying hose
The adjustment of knapsack strap
1. Tighten the strap 2. Loosen the strap
Pull the strap downward. Life strap buckle upward to loosen.
English
Nozzle pipe
Ball cock Spraying hose assembly
Nozzle holder Nozzle holder
Nozzle holder is provided in the top of chemical
tank and side part
The adjustment of chest strap
Pull the chest strap to tighten.
9

Assembly of waist stabilizer

Grip
The concave section of knapsack frame and the
convex section of waist stabilizer are inserted
together.
The adjustment of waist stabilizer
Loosening the adjuster lever, pull out the
1
waist stabilizer.
Adjuster lever
Note when conveying
CAUTION
Don't hold the machine underneath the chemical
tank.
Avoid putting the hand between the chemical
tank and frame.(Watch "Here" in Fig.1)
(For example)
On the pickup truck (Fig.1) you should always
secure the back pack sprayer with a rope.
Concave part
Convex part
How to assemble
Pulling the adjuster lever releases the lock.
Shoulder the machine, push the waist
2
stabilizer from both sides.
Rope
10
Adjuster lever
How to disassemble
"Here"
Fig.1
English