Operating Instructions; Starting Procedure - Maruyama MD181DX CE Manual Del Usuario

OPERATING INSTRUCTIONS

STARTING PROCEDURE

Step#1) Move the "Mist cock" to the closed
position.
Step#2) Pour chemical into the chemical
tank.
Step#3) Close the lib tightly.
PRIMER
BULB
FUEL
RETURN LINE
STEP #4) Pump the "PRIMER BULB" under
of the carburetor until fuel can be
seen flowing through the "FUEL-
RETURN LINE".
If a MARUYAMA engine fails to start after following the above procedures, contact an authorized
MARUYAMA dealer.
Do not spill
the liquid
Close the cover
tightly
CHOKE
LEVER
STEP #5) Move the "CHOKE LEVER" fully
up ward to the closed position. If
the engine is already warm, only a
partial or open (no choke) choke
setting may be required.
STEP #6) Set the throttle lever at 1/2 speed.
CAUTION! Pull the "STARTER GRIP" briskly
to start the engine.
NOTE: Only short pulls are necessary.
Never pull the starter cord to its fullest
extension. Never let go of the starter grip
until it is at the fully returned position.
OPEN
STEP #7) Warming up the engine. When the
engine has started, slowly move the
"CHOKE LEVER" fully upward to the
open position. Allow the engine to
"WARM-UP" at less than 1/2 speed.
7
CLOSE
OPEN
HIGH SPEED
IDLE SPEED
STOP
STARTER GRIP