Type-Identical Identification Marking; Use; Prerequisites For Use; Selecting The Correct Facepiece Size - Dräger FPS 7000 RP Instrucciones De Uso

Type-identical identification marking

The Dräger FPS 7000 RP have different markings:
Connector RP
Facepiece body EPDM or Si,
EN 136:1998 CL.3+,
CExxx (Notified Body in Europe)
Size of facepiece S (small), M (medium), L (large)
body
Size of nose cup 1 (small), 2 (medium), 3 (large)
Visor PCas (coated with scratch-resistant material),
F (fire brigade), according to EN 166
A (ballistic protection class 190 m/s)
T (ballistic protection class at extreme
temperatures, tested at -30...+60 °C with
190 m/s)
Head harness EPDM, CR or Si, M/L, or S
Hairnet H
Drinking valve TR
Use Instructions for NIOSH-approved full facepieces

Use

Prerequisites for Use

Strictly follow OSHA 1910.134 and other valid national regulations for
the use of respiratory equipment.

Selecting the correct facepiece size

The facepiece bodies are available in sizes S, M, L, nose cups in
sizes 1, 2, 3 and head harnesses in sizes M/L and S. In most cases,
the standard size M2 is used. If using this size cannot ensure a
sufficient leaktightness, another size combination must be used.
WARNING
Each facepiece wearer must be provided with a facepiece of
suitable size.
Prior to use, always make sure that the Dräger FPS 7000 RP is
leaktight. The face seal between head and facepiece body must be
free of hair and foreign substances which could cause leakages.
Spectacle wearers should wear mask spectacles.
● Use the correct facepiece size.
● Before using the Dräger FPS 7000 RP for the first time, check that
it is leaktight (see "Leak tests" on Page 138).
133