Safety Instructions Related To The Product And Technology - Aventics CMS Instrucciones De Servicio

58 AVENTICS | CMS, BDC, Stand-Alone | R412008961–BDL–001–AF
For your safety
During assembly
During commissioning
W
You may only commission the product if you have
determined that the end product (such as a machine
or system) in which the AVENTICS products are
installed meets the country-specific provisions,
safety regulations, and standards for the specific
application.
2.6 Safety instructions related to the
product and technology
W
Do not place any mechanical loads on the device under
any circumstances. Do not place any objects on it.
W
Ensure that the power supply is within the stipulated
tolerance for the modules.
W
Observe the safety notes found in your valve system's
operating instructions.
W
A 24 V power pack supplies all components with
electricity. The power pack must be fitted with a safe
isolation in accordance with DIN EN 60742, VDE 0551
classification. This ensures that the electric circuits
comply with SELV/PELV electric circuits in
accordance with IEC 60364-4-41.
W
Switch off the operating voltage before connecting or
disconnecting plugs.
W
The warranty only applies to the delivered
configuration. The warranty will not apply if the
system is incorrectly assembled or manipulated.
W
Make sure the relevant system component is not
under pressure or voltage before assembly or
disassembly. Ensure that the system is prevented
from power restoration during assembly work.
W
Ground the modules and the valve system. Observe
the following standards when installing the system:
– DIN EN 50178, classification VDE 0160
– VDE 0100.
W
Installation may only be performed in a voltage-free and
pressure-free state and only by a qualified technician. In
order to avoid accidents caused by dangerous
movements of the actuators, electrical commissioning
is to be carried out only in a pressure-free state.