S&P EMI-PROGRAM Serie Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

 The radiator should be mounted so that the switches and
other controls are out of reach of anyone in the bath or
shower.
Note: Please respect the limitations detailed in the Low
Voltage Electrical Regulations.
2.-
Additional SAFETY WARNINGS from the manufacturer:
 This appliance has been designed for use as a wall heater
and should only be used for this purpose.
 The heater can be mounted directly on the wall using the
wall brackets supplied (see section 3), or attached to floor
supports using the floor support kit (see section 4), which is
sold separately.
 The radiator should not be used when in direct contact with
the floor.
 The heater should only be attached to the wall using the
bracket supplied with the appliance. (see section 4)
 Please
specifications required for this appliance: 230 V ~ 50Hz.
 Make sure that the wall the heater is attached to is able to
bear the weight of the radiator.
 The radiator should be mounted on a perfectly straight level,
both vertically and horizontally.
 Take care to respect the specified minimum distances for
assembly, as detailed in Figure 1.
 The appliance should not be mounted in a recessed position
(under a table, desk, counter, etc.) where this interferes with
the air circulation in and out of the radiator.
ensure
that
your
power
16
supply
meets
the

Publicidad

Tabla de contenido
loading

Tabla de contenido