S&P EMI-PROGRAM Serie Manual De Instrucciones página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

 While the radiator is in operation, the power cable should be
completely unwound and should not be in contact with the
heated part of the appliance.
 Do not use the radiator to dry clothes.
 Do not use the appliance with wet hands.
 Make sure the appliance has been disconnected from the
power supply before cleaning or performing maintenance
work on it.
 For indoor use only
3.-
MOUNTING THE RADIATOR USING THE WALL BRACKET
As far as possible, try to mount the radiator on an inner (cold) wall beneath a
window, but never in a ventilation area. Make sure to respect the safety distances
indicated for correct installation (Figure 1).
.- Place the wall bracket on the floor where you wish to mount the radiator. Next,
mark the position of the two upper holes in the wall bracket on the wall (Figure
2.a.).
.- Drill the two holes with a Ø6mm drill bit (Figure 2.b).
.- Put the two S6 screw anchors in place. Using two screws, temporarily attach
the wall bracket using the two lower holes (Figure 2.c.), then mark the position of
the two upper holes.
.- Remove the bracket and drill the two upper holes as marked (Figure 2.d.).
.- Attach the bracket to the wall in its final position (Figure 2e.f.). Make sure
everything is level, both vertically and horizontally.
.- Attach the heater to the wall bracket, so that the main body of the appliance is
in the center of the wall bracket (Figure 2.g).
.- To make sure the heater is installed correctly, and to avoid the appliance
coming off the wall by accident, you should put the safety pieces in place,
inserting them in the slots in the heater. (Figure 2.h)
.- Make sure the safety pieces are positioned correctly, as shown below.
.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido