S&P EMI-PROGRAM Serie Manual De Instrucciones página 23

.- Go into comfort mode by pressing the m/Ok button, then use the "-
"button to reduce the temperature to the minimum level (7ºC).
.- Next, press the "+" button to increase the comfort temperature until the
heat up, which means the temperature shown on the screen is the room
temperature detected by the radiator.
.- If the room temperature detected is more than 2ºC different from the
actual room temperature, you can compensate for the difference as shown
below.
Compensation
This adjustment can increase or decrease the temperature detected by the
thermostat probe.
.- The radiator should be in INACTIVE mode, which means that only the
icon should appear on screen. Otherwise, press the
control panel until you set the correct mode.
.- Press and hold the m/ok button to enter compensation mode, until the
screen shows 0.0.
.- Use the "+" and "–" buttons to adjust the compensation depending on
the difference you detected during the previous stage.
.- Next, press the m/ok button (short press), until the screen shows the
radiator is turned off. Next, turn off the radiator using the switch on the
back for 5 seconds, so that saves the data.
6.5 Warnings and running errors
.- If the room temperature drops below -15ºC, the screen will show the message
OC.
.- If the room temperature is higher than +50ºC, the screen will show the
message SC.
7.- Maintenance
Make sure the appliance has been disconnected from the power supply before
performing maintenance work.
The radiator does not need any special maintenance. We advise you to remove
dust from the radiator using a dry cloth. Always clean the radiator while it is cold,
and avoid using solvents and abrasive products to clean it.
symbol appears on screen. This is when the radiator should start to
23
button on the