Safety Regulations For Airless Spraying; Explanation Of Symbols Used - Titan Airless 1650e Serie Instrucciones De Uso

Safety Regulations
1. Safety regulations for Airless
spraying
1.1

Explanation of symbols used

This manual contains information that must
be read and understood before using the
equipment. When you come to an area that has
one of the following symbols, pay particular
attention and make certain to heed the
safeguard.
This symbol indicates a potential
hazard that may cause serious
injury or loss of life. Important
safety information will follow.
This symbol indicates a potential
hazard to you or to the equipment.
Important information that tells
Attention
how to prevent damage to the
equipment or how to avoid causes
of minor injuries will follow.
Danger of skin injection
Danger of fire from solvent and
paint fumes
Danger of explosion from solvent,
paint fumes and incompatible
materials
Danger of injury from inhalation
of harmful vapors
Notes give important information
i
which should be given special
attention.
GB
HAZARD: INjECTION INjuRy
Attention: Danger of injury by
injection! A high pressure stream
produced by this equipment can
pierce the skin and underlying
tissues, leading to serious injury and
possible amputation.
Do not treat a spraying injury as
a harmless cut. In case of injury to
the skin through coating materials
or solvents, consult a doctor
immediately for quick and expert
treatment. Inform the doctor about
the coating material or solvent used.
PREVENTION:
• NEVER aim the gun at any part of the body.
• NEVER allow any part of the body to touch
the fluid stream. DO NOT allow body to
touch a leak in the fluid hose.
• NEVER put your hand in front of the gun.
Gloves will not provide protection against
an injection injury.
• ALWAYS lock the gun trigger, shut the fluid
pump off and release all pressure before
servicing, cleaning the tip guard, changing
tips, or leaving unattended. Pressure will
not be released by turning off the engine.
The PRIME/SPRAY valve or pressure bleed
valve must be turned to their appropriate
positions to relieve system pressure.
• ALWAYS keep tip guard in place while
spraying. The tip guard provides some
protection but is mainly a warning device.
• ALWAYS remove the spray tip before
flushing or cleaning the system.
• NEVER use a spray gun without a working
trigger lock and trigger guard in place.
• All accessories must be rated at or above
the maximum operating pressure range of
the sprayer. This includes spray tips, guns,
extensions, and hose.
4 Performance Series 1650e