Press the steam button
least 3 seconds.
The machine will start dispensing
hot water; the steam button
will fl ash rapidly.
Press the steam button
again on reaching the desired
quantity of water.
PREPARING COFFEE AFTER
GENERATING STEAM
It is very important to avoid making coffee right after dispens-
ing steam because the water generated by the thermo block is
too hot and will impair the fl avor of the coffee.
For this reason the coffee button
thermo block temperature is too high.
To switch the machine back to the
coffee mode, press the coffee but-
ton and wait until the
lights up; during this cooling down
phase (approximately 10 minutes),
the cup icon in the central circle
will fl ash.
To switch the machine back to the coffee mode quickly (ap-
proximately 1 minute), carry out the following steps:
Place a metal pitcher beneath the
steam wand.
21
for at
DESCALING
1. If the icon on the circle fl ashes (1 fl ash every two sec-
onds)
consists of 2 phases: a descaling phase (duration: about
14 minutes) and a rinse phase (duration: about 3 min-
utes).
2. Limescale normally builds up with the use of the ma-
chine. The machine is equipped with an automatic pro-
gram allowing you to optimise cleaning and to remove
is disabled when the
limescale deposits from the inside. If the descaling pro-
cedures are not carried out, limescale may cause mal-
functions not covered by the warranty.
3. Only use descaling products for coffee machines. Do not
use vinegar, lye, salt or formic acid as they may dam-
button
age the machine. Follow the procedure described below
and not the instructions on the package of the descaling
product.
4. Should a power failure occur during the descaling pro-
cedure, the cycle will resume from where it stopped
when power is restored.
Keep the steam button
sed down for 3 seconds.
A programmed quantity of hot wa-
ter will be dispensed; the fl ow will
stop automatically.
, you need to descale the machine. The cycle
Turn off the machine.
EN
pres-