Outgoing Speech Amplification (Osa) - Clarity Alto PLUS Manual De Uso

MENU OPERATIONS
"Clarity" is displayed on the screen in idle mode if the following standby screens are not
applicable:
The number of CID calls are shown on screen: "1 Call"
"No Ph Line" is displayed if the phone line is not plugged in .
"Batt Only" is displayed alternatively with "No DC power" if the power adapter is not
plugged in (no power) .
"Line In Use" is shown if another phone on the same phone line is being used .
"New VMail" is shown if you have a new voicemail message (service purchased separately
from your phone service provider) .
NOTE: If there is a new CID, "New VMail" and the number of new CID entries
screen (example: "2 Calls") will alternate.

Outgoing Speech Amplification (OSA)

This function amplifies your speech so it becomes louder to the person on the other end of
the call . To enable this function, press and hold the BOOST button for five seconds .
The phone beeps; the function can be enabled/disabled while on a phone call or in standby
mode . The OSA light (part of the visual ringer)turns on when this function is enabled .
To return to the default setting for your voice volume level, press and hold the BOOST
button again for three seconds . You will hear a beep confirming that the function is disabled .
Figure 14
NOTE: In order to experience the best audio quality for both parties during a
call, we recommend you turn on this function only if your voice is too quiet.
OSA is not active in speakerphone mode.
23