Rivacold FS Serie Manual De Uso Y Mantenimiento página 46

4.1.1. Power and Utilities
The power supplies and utilities necessary (responsibility of the purchaser) for machine functioning exclusively consist in the supply of
electrical energy.
Unless otherwise indicated, the purchaser is responsible for:
the preparation of transport vehicles to transport the machine to the assembly or installation location;
the preparation of equipment necessary for assembly and installation;
the preparation of the installation location;
the preparation of auxiliary vehicles and consumable materials (for example, non-flammable and non-corrosive detergents,
materials and tools necessary for cleaning and cover).
4.2. Transportation and Movement
The instructions contained in this paragraph must be followed during machine transportation and moving which can occur in the
following situations:
machine storage;
assembly and the first installation of the machine;
de-installation and dismantling of the machine;
moving and relocating the machine.
DANGER:
To conduct the task in question, the following Individual Protection Devices are necessary:
During transportation or moving of the machine, the following warnings must be followed:
Make sure all lifting equipment is suitable for the weight and size of the machine (check the technical specifications for the
various types of Blocksystem FS as reported in Chapter 9 - Attachments).
Do not strike the structure or guards on the machine with tools or any other object.
4.2.1. Lifting
DANGER:
Lifting to move and subsequently position the machine can be performed using any adequate vehicle that guarantees its lifting in a
safe and efficient manner (for example a hoist using a harness system for the machine). See Figure 2.
To correctly perform the lifting operations, follow the warnings reported below.
Never use two lifting vehicles simultaneously.
Never stay under suspended loads.
If using steel ropes, always apply the end eye to the lifting hook.
If using steel ropes, pay attention not to create sharp bends, i.e. with a bending radius lower than that of the rope end eyelets.
Use adequately wide ropes, to enable the angle between the ropes and the horizon to always be over 45°.
4.2.2. Machine movement
For reduced distances, as in the case of transport to the assembly or storage locations of the machine, it is necessary to use lifting
equipment (for example, forklift and hoists) suitable for the dimensions and weight of the machine.
ATTENTION:
DANGER:
4.3. Installation
DANGER:
To conduct the task in question, the following Individual Protection Devices are necessary:
the Manufacturer denies any responsibility for any damages to persons and/or property, stemming
from improper operations performed by unqualified, untrained, or unauthorized personnel.
lifting operations must be conducted with the direct supervision of a qualified mechanical maintenance
person or a manufacturer technician.
during all these operations follow the precautions necessary to avoid knocking and tipping over, moving
the machine in a manner not to loose balance.
ensure there are no unauthorised staff near the zone where the lifting, movement and unloading operations
take place and always keep a safe distance.
the Manufacturer denies any responsibility for any damages to persons and/or property stemming
from improper operations performed by unqualified, untrained, or unauthorized personnel.
UK
FS Pag. 46 Rev 00 02/12