Transportation; Service And Maintenance - Festool CSC SYS 50 EBI Manual De Instrucciones

English
► Unlock and swivel the saw blade flap [15-1]
downwards.
► CAUTION! Wear protective gloves.
Remove any remaining parts of the work­
piece and use an extractor in the area
around the saw blade.
► Close the saw blade flap and fit the cover
plate.
► Insert the hex key into the holder [1-10]
provided.

11 Transportation

CAUTION
Risk of injury!
The power tool may slip out of your hands
when you are carrying it.
► Always carry the power tool with both
hands, using the gripping surfaces [1-1]
provided on both sides of the power tool.
► When carrying with the carrying han­
dle [1-24], ensure that the lid is secured
with both locking clips.
CAUTION
Risk of injury
The sliding table may extend. The extension
table may unfold.
► The power tool must always be transported
in the transport position that has been pro­
vided for this purpose.
11.1 Securing the power tool (transport
position)
► Move the saw blade to the parked position
with the control module (select favourite
"P").
► Use the main switch to switch off the power
tool (see section 7.3).
► Lock the sliding table in position (see sec­
tion 9.13).
► Fold the extension table (see section 9.11).
► Push the stop rails together until the two
adjustment markings for the parked posi­
tion (see section 1) are facing each other.
► Put the parallel side fence on the power tool
in parked position [16B].
► Stow the spacer wedge with protective cov­
er and the remaining accessories in the
lid [16A]. The preset profile setting rail can
also be attached to the power tool in parked
position [16B].
► Close the lid and secure it with the two
locking clips.
38
The power tool is in the transport position.

12 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating instructions.
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
► Use an extractor to remove dust deposits,
splinters and chips (see section 10.8).
12.1 Adjusting the extension table height
► Image [17]
12.2 Adjusting the sliding table height [18]
If the height of the sliding table no longer
matches the height of the plate:
► Move the sliding table into the front posi­
tion.
► Remove the cover cap [18-1] and undo the
screw underneath it.
► Move the sliding table into the back posi­
tion.
► Remove the cover cap [18-2] and undo the
screw.
► Adjust the height of the sliding table with
the adjusting screws [18-3] and [18-4].
Turn to the right = lower
Turn to the left = lift
► Tighten the screws [18-1]
and [18-2] (3.5 Nm) and fit the cover caps.